Brembo M10 bleed nipple kit containing M10 bleed nipple and rubber cap. M10 bleed screw used only on rear of 2003 on models

Brembo no. 98.8249.20

 This part is available by special order, request a quote

 17659260 GU17659260 17 65 92 60
 1765 9260 1765.9260 17.65.92.60

A2 stainless steel socket cap bolt

 This part is available by special order, request a quote

Left hand Domino type switchgear with high and low beam, pass, indicator and horn switches. Same style switch as ELA01738

On most bikes this will not plug directly into the wiring loom, you will need to match the wires to your loom. An indication of wire colours is supplied with this switchgear. Supplied with 9 pin block connector. NB does not have lights off - park - on function, you need this to be on your RH switch (e.g. ELA01729 ) or run lights always on

 This part is available by special order, request a quote

Discontinued by Bosch, superceded to 97729R. Also see ELA05731 for new replacement part or ELC05730 for reconditioned alternative

 This part is available by special order, request a quote

 05730730 GU05730730 05 73 07 30
 0573 0730 0573.0730 05.73.07.30

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

NE5

Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

12V 30A 4 pin relay

Various uses including ignition, fuelling and starter relay

 This part is due back in stock soon, call 01484 841395 to reserve yours

AP8224462

Retaining bolt for oil filter cover

See SSA27885 for less expensive stainless alternative

 This part is available by special order, request a quote

 27152885 GU27152885 27 15 28 85
 2715 2885 2715.2885 27.15.28.85

Screw in polished alloy thermometer dipstick with O ring. Shows oil temperature in degrees celcius

Supplied unmarked, you will need to mark the rod using a small file to match your existing dipstick

 This part is due back in stock soon, call 01484 841395 to reserve yours